French & Double Doors

French & Double Doors in Greenacres, FL | TruePane Windows & Doors

French and double doors bring something no sliding door can match: a wide, symmetrical opening that connects your living room to the patio, your dining area to the pool deck, or your bedroom to the morning light. But here in Greenacres, a standard French door is a liability. Our impact-rated French and double doors are built for the Florida reality, with laminated glass in every lite and multi-point locking hardware that holds the panels tight when the wind tries to pry them open. We install these doors throughout Greenacres, and we do it with the same care we’d give our own home. Call (754) 339-0784 to talk about your opening.

Call (754) 339-0784

Product Overview - French & Double Doors

Our French and double doors are paired, hinge-swing panels that open from the center, giving you a clean sightline through the opening when closed and a wide, unobstructed passage when open. Think of them as the architectural counterpoint to a sliding glass door: traditional, balanced, and inherently symmetrical. In a Greenacres home, they’re often the transition point between an interior great room and a screened lanai, or between a primary suite and a covered porch.

What separates these from a big-box French door is what’s inside the frame. Every lite carries laminated impact glass, not a single tempered pane. That’s the same glass technology used in hurricane-rated windows: two layers of glass bonded with a PVB interlayer that holds the assembly together if something hits it. The frames are aluminum or vinyl depending on your elevation, exposure, and the look you’re after. The locking system is multi-point, meaning the door doesn’t rely on a single deadbolt at the handle; it engages at the top, bottom, and mid-rail so the active panel stays sealed when Greenacres gets hit with wind-driven rain.

TruePane Windows & Doors supplies these through our PGT, CGI, CWS, ES Windows, ECO, and Mr-Glass lines. Each line has its own profile and hardware details, but all of them get installed to the same standard: level, plumb, square, and sealed against the Florida afternoon storm.

Technical Specifications

Here’s what you’re working with when you specify an impact-rated French or double door through TruePane Windows & Doors:

• Frame materials: Aluminum or vinyl. Aluminum is our go-to for wider openings and modern elevations; vinyl brings strong thermal performance and a lower maintenance profile for Greenacres homes in shaded lots.
• Maximum size: Up to 96 inches wide across the pair, depending on the configuration and the design pressure required for your wind zone.
• Impact glass options: Laminated impact glass with PVB interlayer, Low-E insulated glass, tinted glass, or clear glass. Glass selection affects both energy performance and how the door reads from the street.
• Finish options: White, almond, bronze, black, and tan. These are the standard powder-coat and finish choices; the right one depends on your home’s palette, not just preference.
• Configuration: Single active panel with a fixed panel (sometimes called a “one active, one passive” setup) or both panels active depending on how you’ll use the opening day to day.
• Hardware: Multi-point locking system on the active panel, with flush bolts on the passive panel. Hardware finishes selected at quote time.

Hurricane & Compliance Performance

Laminated Impact Glass
Every lite in these doors uses laminated glass with a PVB interlayer. When an object strikes the surface, the outer layer may fracture, but the interlayer holds the glass in the frame. That means no breach, no flying shards, and no water intrusion while you wait to replace the lite. This is the same principle our horizontal roller and sliding windows use, applied to a swing-door profile.

Miami-Dade NOA and Florida Product Approval
Each door configuration carries a Miami-Dade Notice of Acceptance and a Florida Product Approval number. These are issued per configuration, not as a blanket rating, so the specific size, frame, and glass combination on your quote will have its own approval number. We’ll provide it with your paperwork; your Greenacres permit reviewer wants to see it.

FBC / HVHZ Compliance
These doors are engineered to Florida Building Code High-Velocity Hurricane Zone requirements. That’s the strictest wind-borne debris region standard in the state, and Greenacres sits inside it. A door that says “hurricane rated” but isn’t FBC-HVHZ compliant doesn’t belong in your opening.

TAS 201 / 202 / 203 Testing Context
HVHZ-rated products are tested under a specific protocol family. TAS 201 covers large-missile impact: a piece of lumber launched at the glass and frame to see if the assembly holds. TAS 202 covers cyclic wind-pressure loading: the door gets pushed and pulled thousands of times to simulate hurricane conditions. TAS 203 covers forced-entry resistance: someone trying to defeat the door from the outside. These three tests are the basis for the NOA and Florida Product Approval our doors carry.

Design Pressure Matched to Your Wind Zone
Design pressure (DP) is the amount of wind force the door can resist without failure. These doors are rated up to +/-100 DP, and that number gets matched to your specific wind zone in Greenacres during quoting. We never sell a door rated higher than what your opening needs, and we’d rather show you the math than throw a number at you. Your exact DP comes from the configuration, not from a catalog page.

Energy Performance Options
If you want the impact protection without sacrificing energy efficiency, Low-E insulated glass is available on these doors. The Low-E coating reduces heat transfer through the glass, and the insulated airspace helps keep the conditioned air inside where it belongs. In a Greenacres summer, that’s not a luxury; it’s the difference between a comfortable great room and a heat sink against the west wall.

Color & Glass Options

The finish on your French or double door sets the tone for the whole rear elevation. White is the cleanest look and disappears into most traditional Florida interiors. Almond and tan work beautifully on homes with stucco exteriors in warm earth tones, which we see all over Greenacres from the older sections near 10th Avenue North to the newer developments west of Jog Road. Bronze reads more substantial and hides wear well; it pairs nicely with darker trim and modern elevations. Black is the boldest choice and it’s increasingly popular on coastal Mediterranean and contemporary builds. All five finishes are baked on at the factory, not painted in the field.

For glass, clear laminated is the default because it preserves the truest view and the highest visible light. Tinted glass cuts glare on south and west-facing openings and gives you a bit more privacy. Low-E insulated glass is the pick when the door faces the afternoon sun and you want to keep the room cool without closing the blinds by 2 p.m. You can also combine tinted and Low-E on one package depending on the line.

Installation by TruePane Windows & Doors in Greenacres

A French or double door that passes TAS testing in a lab can still fail in a Greenacres home if the installation isn’t done right. The NOA and Florida Product Approval numbers only apply when the product is installed correctly. A sloppy install means uneven reveal lines, a door that rubs or binds, and a perimeter seal that won’t hold up to driven rain.

That’s why we control the entire process. We start with a pre-install inspection of the rough opening to check the condition of the buck, the subfloor, and the header. If something’s rotten or out of square, we fix it before the door goes in. We set the frame level, plumb, and square, which on a 96-inch double door takes patience and shims in the right places. We fill the perimeter with AAMA 812-compliant low-expansion foam, then seal the exterior with a continuous bead that channels water away from the opening. The entire installation follows AAMA 2400 and 2410 practice for fenestration installation.

After the door is hung and the panels are adjusted, we run a water test around the perimeter and check the multi-point hardware engagement. We also handle the permitting side for Greenacres homeowners: your door will need a permit, and the Miami-Dade NOA or Florida Product Approval submittal has to be included. We know what the local reviewers want to see, and we provide it with the package.

One more Greenacres-specific note: many homes here sit close to each other, which means wind funnels between houses can exceed what the maps suggest. We look at the actual exposure when we size your design pressure. If your door faces a neighbor’s wall 12 feet away, the wind load behaves differently than an open field scenario, and we account for that.

Frequently Asked Questions - French & Double Doors

Get a Quote - French & Double Doors in Greenacres

If you’re planning a new opening or replacing an old French door in Greenacres, start with a conversation. We’ll measure the opening, confirm your wind zone, pull the right NOA paperwork, and give you a written line-item quote with no surprises. Call TruePane Windows & Doors at (754) 339-0784 to schedule your free on-site measurement.

Written by the team at TruePane Windows & Doors, serving Greenacres, FL and surrounding Palm Beach County communities.