Simonton Sliding & Patio Doors Nationwide | TruePane Windows & Doors

Simonton Sliding & Patio Doors: The Greenacres Owner’s Guide

Simonton sliding and patio door part replacement in Greenacres typically runs $95 to $420 per part installed, with full roller-and-track rebuilds landing between $380 and $700 depending on the door’s age and series. We stock common Simonton-compatible rollers, handles, locks, and weatherstripping on our trucks, so on most calls we can pull the old part, match it in the driveway, and have the door sliding right the same day. What usually brings Greenacres homeowners to this page is a door that suddenly needs two hands and a shoulder to open, a lock that no longer catches, or a cloud of humidity settling between the glass where a seal has finally given up after twenty Florida summers.

Call (754) 339-0784

Which Simonton Models This Applies To

TruePane repairs and replaces parts for the Simonton sliding door lines most common in Palm Beach County homes: the Simonton StormBreaker Plus, the 5500 and 6500 series sliding patio doors, and the older 9800 and Reflections 5050 lines still running in houses built through the 1990s and early 2000s. The critical identification step is reading the label, not guessing. Simonton etches or prints the model, series, and sometimes the manufacturing date on a sticker inside the door frame head or on the edge of the panel itself. If that sticker is gone, which happens often after decades of Florida humidity, we measure the roller housing width, the stile thickness, and the mortise depth before we quote anything.

A compatibility gotcha we see regularly: Simonton changed roller housing dimensions between the 5500 and 6500 series, and the rollers are not interchangeable even though both doors look identical from the outside. The 5500 uses a 7/8-inch adjustable steel housing; the 6500 takes a 1-inch housing with a different wheel profile. An aftermarket roller labeled “fits Simonton” often fits one, not the other. We carry both OEM Simonton parts and a short list of aftermarket equivalents we have verified on Greenacres jobs. Our rule is simple: if the door is a StormBreaker Plus or any impact-rated Simonton line, we install OEM. The tolerances and the warranty registration depend on it. For non-impact doors, a quality aftermarket roller can equal OEM performance at fifteen to thirty percent less, and we will tell you which we would put in our own house.

One more thing worth knowing: TruePane is an independent service provider, not affiliated with Simonton. We are a local installer and repair shop that stocks Simonton-compatible parts because they are on thousands of Greenacres doors. We also carry Andersen, and Pella parts for homes with mixed brands.

Signs Your Simonton Sliding & Patio Doors Is Failing

• The door drags or takes real effort to move. This is almost always worn rollers. Simonton rollers use a nylon wheel over a steel bearing, and in Greenacres the combination of humidity, salt air, and years of fine sand in the track grinds the wheel flat. Once the wheel is flat, the panel rides on the housing, and every open and close is scraping metal on aluminum.
• You hear a grinding or gravel sound when sliding. That is the wheel bearing gone dry and the track collecting grit. Lubricating a worn set of rollers buys a week, not a season. The fix is replacement, and the track gets cleaned and reconditioned at the same time.
• The lock lever flops or will not engage the keeper. Simonton lock mechanisms wear at the pawl, the small curved piece that hooks into the jamb. After enough years, the pawl rounds off, and the lever just swings without catching. This is also a security issue, because the door is not actually locked even if it feels closed.
• Moisture or fog shows up between the panes. That is a failed insulated glass seal. In Greenacres, where summer dew points run over 70 degrees for months, a failed seal shows itself fast. The glass is not cracked, but the argon or krypton fill has leaked out and humid air has taken its place. You cannot wipe it off; the surface is clean, the fog is inside.
• Weatherstripping is peeling, flattened, or letting daylight through along the interlock. This shows up as heat gain, higher AC bills, and sometimes a thin line of dust or water along the sill after a driving rain. On Simonton doors, the interlock weatherstrip is a specific profile, not a generic peel-and-stick.

Replacement Cost & What’s Included

For Simonton sliding and patio door parts in Greenacres, here is the pricing we work from:

• Roller replacement (both panels): $180 to $340 installed
• Handle and lock assembly (non-impact): $95 to $165 installed
• Handle and lock assembly (StormBreaker Plus or multi-point): $210 to $420 installed
• Interlock and perimeter weatherstripping (full door): $140 to $280 installed
• Track reconditioning and alignment: $120 to $260, often added to any roller job
• Insulated glass replacement (seal failure): $280 to $620 per panel, depending on glass width, coating, and impact rating

What drives the range: impact-rated parts cost more because the components are heavier and the tolerances are tighter. Doors with painted frames or older series that have been discontinued require more labor to match. Our quote includes the part, the labor, cleanup, and a written line-item showing exactly what we are installing. We register warranty documents before the truck leaves your driveway, and the work is covered by our Done Right Promise. If it is not right, we come back and make it right without a paperwork fight.

DIY or Call Us?

A homeowner in Greenacres can safely check a few things before picking up the phone. Look at the track: is it full of sand and old lubricant? Clean it with a dry brush and a vacuum. Check the rollers by looking under the panel with a mirror and a flashlight. If the wheel looks squared off or the housing is tilted, you have your answer. Do the same with the lock: close the door slowly and watch whether the pawl engages the keeper.

Where DIY goes wrong is forcing the panel. A sliding glass door panel weighs 90 to 180 pounds, and when a homeowner lifts it without releasing the adjustment screws properly, the frame bends, the glass stress-cracks, or the panel comes off the track and lands on a foot. We have repaired doors where the previous fix involved a pry bar and a bad temper. Replacing rollers means the panel comes out, and on a Simonton StormBreaker Plus, that panel is heavy enough that we send two people. Most of the repair jobs Dale Kessler runs in Greenacres are a one-visit fix. The repair is almost always cheaper than the hospital bill or a new door. Call us at (754) 339-0784 and we will tell you over the phone what you are likely looking at before we ever schedule the truck.

FAQs

Contact TruePane Windows & Doors

If your Simonton sliding door is dragging, rattling, or not locking, call us at (754) 339-0784. We will walk through what you are seeing, give you a straight answer on what it likely costs, and schedule a time that works. The estimate is free, the pricing is upfront, and the work is guaranteed by the Done Right Promise. We have been serving Greenacres homeowners since 2008, and we plan to be here answering the phone for the next thirty.

Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Greenacres and nearby areas.